Search results

Ive been researching this but need some clarity. My shop heater is propane, ran from regulator with black pipe and transitions to gastight csst into the heater. Im unsure how to bond it. My shop is wired in EMT conduit. Can I just run a bond wire from the furnace black pipe to the EMT, is does...

Ok, so i think i have about read every post about shop heat units on this forum and others. The problem i have is venting. I originally wanted to go horizontal but because of my sofits being about 9' from ground and 1.5' overhang i think it will look ugly, and very expensive compared to vertical...

Ontario Canada I recently purchased a home with a 32x48' pole shed that was used as a hobby barn. It was somewhat insulated, walls are spray foamed, attic is blown in. I strapped the walls and installed r12 batts and lined with steel. I am in the process of installing steel on the ceiling. I...

Hi all, Ill be renovating a newly acquired shop soon and wondering about lights. Ive picked up some 6 bulb t5 hi-bay lights relatively cheap and was hoping to make them work in a shop that is 32x48x9. The shop will be getting a concrete floor and is being lined with white steel. Is there a way...

Hi all, i've been lurking with forum for the past 6 years reading all the interesting discussions. Now i finally have a question to ask. I have a swan twin cylinder, single stage air compressor. It has a 40gallon tank and 5hp motor. Since i got it (second hand) the one cylinder wasn't nearly as...