Search results

I just bought a Honeywell CT31A for my 45K heater. I am thinking I may have bought the wrong thermostat. They back of the heater has the following terminals: C W G R The Thermostat only has Y G R W Did I get the wrong one?

I know some of these question have been beat to death but search is not turning up anything easy. I just installed my heater on the ceiling. I have not ran the gas line or vent yet. I'll probably do that sometime this fall before it gets cold. Can I run the fan on the unit to circulate air this...

I just finished the drywall and used a knock down texture. I would like to paint a 12" strip around the whole room. What's the best way to tape it so there won't be any bleed throught. I would like to get a good crisp line.

Just finished sheetrock/mud/texture. What is the purpose of PVA primer? Do I need it or can I just roll on the paint? I am guessing it will not soak up so much paint if I prime it first but is there any other reason?

I am going to lay down some racedeck in my new shop. I would like some help on the layout. My building has two rooms, the main shop and an office. I would like to have the layout even around all sides but am trying to figure out to connect it through the door so all the tiles match up. How do...

I am looking for some ideas on how to finish the edges of my concrete slab. I just built a new shop (24x36). I poured the foundation wall 6 inches wide. The framing is 2x4 which left me with a rough edge and expansion board all the way around. Originally, I was planning on using epoxy on the...