Search results

I just purchased a Powermatic 66 table saw, its a beast, but it needs a little TLC. The PO was a cabinet shop, and they glued a piece of Formica onto the cast iron table. (I guess instead of the maintenance of polishing and waxing). Its old beat up, cracked, and needs to go. I tried...

I am getting ready to do an application of 4500/8510 ghostshield on a 840sq ft garage. Any recommendations for a good sprayer

I am getting ready to wire the workshop, and thinking of future equipment upgrades. Currently the table saw and air compressor are 110V. I will be upgrading to a 220v saw, and could foresee a 220V compressor someday as well. So, I figure I should go ahead and run 12/3 on those 2 circuits...

The PoCo came out yesterday and told me the garage is going to be too close to the service line, and the service line either has to go underground, or main feed the garage and then feed the house from the garage. As I think this through, I want to be sure I understand the bonded ground...

This should be a basic question, but I have had 2 different answers. The main breaker is a 2 pole 100A breaker. So, you would think its a 100a box. How can I tell if the wire to the meter box needs to be upgraded? I am building a 30x28 garage, planning to run a 100a box in the garage fed...