Search results

hello all, just wanted to share some photos of my recently finished garage floor project. first, i cut a section out to re-pour a sunken section for a mid rise lift then had someone come in and re-poured for me. its 12 inches wide and 12 inches deep around all 4 sides with 1/2 inch rebar...

long story short.... i am installing a mid-rise lift that is in a re-poured section of the floor which is dropped down 5 inches below the original floor. when all is done i was thinking about installing racedeck in the lower section as well as around the perimeter of it on the original floor...

so about 2 1/2 years ago we tore out the old concrete floor in my garage and re-did the entire thing. everything went well, but now i have an issue on the outside edge of the concrete where it meets the driveway. i have a section about a foot wide, and the length of the door opening of the...

most peoples garage floors have been power trowled to give that "smooth" finish to them. my question is for those that have that done, is there an issue with epoxy coating the floor? do you have to grind the floor to make it rough so the epoxy will bite better?

so i just had my new floor poured and after it cures i plan on epoxy coating it. my builder had put an 1/8th inch relief cut right down the center of the floor that is several inches deep (near the bottom of concrete). my question is this: if i fill that with a filler that people use before...

the wife and i bought our house a little over 2 years and everything was great in the house except the garage floor which the original owner did himself and did the entire thing wrong and half assed. so my father-in law and I as well as my father tore out the old floor, dugg down and poured the...