Search results

I recently bought two sets of Wright Grip wrenches, one SAE and one metric. I was very surprised at the poor quality chroming, is this normal or did I get a bad production run? The SAE wrenches are a lot worse than the metric ones. These are brand new, never been used wrenches purchased from...

A few weeks ago I ordered a set of both metric and imperial Bondhus ball-end T-handle hex wrenches from DGI Supply. After not hearing anything for a couple weeks I reached out to them to see what was going on. They told me Bondhus wouldn't be able to ship the product until the end of February...

I have an application where I need to attach and remove a long hex bolt with some frequency that engages a mechanism that cannot handle a lot of torque (I believe the tightening spec is around 3 NM or roughly 2.21 ft-lbs). I'm fine with doing the final tightening by hand with a torque wrench...

I am looking to buy a couple standard length 6 point socket sets in 3/8 drive, one set metric and the other SAE. I like both Williams and Koken (although I'm open to other non-box store brands if you have suggestions) and have always liked the idea of Snap-On's Flank Drive/Williams' SuperTorque...