Search results

I repurpose antiques and need to powder coat a few larger objects. I bought for $130.00 a food warmer that is made out of aluminum with a little bit of insulation. I am insulating the outside with Rock Wool in a 2 x 4 Steel stud frame and skin. (All on the outside to help with the insulating...

I have built a welding table but found that my 1/2" 3' x 4' plate is arced. I can pull it down with clamps to straighten it but which way should I pull the arc? Should I place it on the table as an upside down letter "U" or place it on the table like the letter "U"? Any help is appreciated...

I have a Ridgid 14" abrasive chop saw and it's ok, but I saw a carbide chop saw and tried it out at a shop and loved it. The cuts were clean, no burrs and dead on. There was no blade wobble like the abrasive saw and you can re - cut material like a wood chop saw and take a little off. Something...

Alright guys here goes, I have looked over the net and found a pretty compact and simple design for a compressor dryer. But where I am stumped is in the area of getting rid of the water. Most applications want you to route the discharge tube from the pump itself to the dryer then into the tank...

I have read all I can possibly read about VCT, Epoxy coats and hard tile. I am just thinking, what would happen if I cleaned the floor and stained it then put a sealer over it? I fabricate and weld, work on cars in my garage and want to keep as much money in my pocket. Can it be done and does...

I have a Millermatic 211 and I love it, being a novice welder I have two questions. The first, can I leave my shield gas gauge turned to the proper psi when I am done welding and have turned off the gas and purged my line? The second, has anyone ever made a folding welding table? :dunno: