Search results

I made a set (4) of ramps out of 2" x 12"s to get a late model corvette high enough off the ground to then use a low profile floor jack to lift the car properly. Each ramp is 4 foot long with a 2 foot long piece stacked on top and screwed together. The leading edge of each is cut on a 30 degree...

I scrounged a dozen 4' x 16' (.060" thick) sheets of polished diamond plate aluminum at scrap value to run around the perimeter of my pole barn walls and I want to cut them down to 2' x 16'. What is the best way to cut this material without distortion and hopefully straight? A metal cutting...