Search results

Has anyone seen one of these presses with a lathe kit? I bought it this morning on craigslist, couldn't find any information online anywhere. I was just looking for a relatively inexpensive floor standing drill press and chose to get this for $250 instead of spending $350 for a new one from...

The bottom 2 feet of my garage walls are concrete block and I'm thinking about fastening some sort of rubber to the top 6 inches or so in order to prevent dents on my car doors if I accidentally let the doors open too far. Anyone know of anything I can use for this? I did a search on this...

My new house has an attached garage with 11 foot high ceilings. The depth is 21 feet and the width is also 21 feet. It currently has 2 small garage doors, 8 feet wide and 7 feet high. I am looking into the possibility of getting 1 large 18 foot wide by 8-10 foot high door. I would also like a...

Attached are photos of my garage. It's 24 feet wide, 40 feet long and the ceilings are about 16 feet high. In the back right corner is a bathroom with a shower, sink and toilet bowl. The heat is fuel oil hot air, hung from the ceiling, with it's own 275 gallon tank. There's a drain in the floor...