Search results

While I have yet to do any hot water in my shop, based upon experience at my northern WI cabin with a good sized tankless propane water heater I would say that is the BEST choice. I did the installation myself, including a power vent because it goes horizontally once in the attic. One never runs...

Thinking of buying/intalling a radiant system from Roberts-Gordon. My shop 40x55' has R40 insulated 12.5' ceiling, 2" of closed cell spray-on foam in side walls. It looks to me like ceiling installation not possible because the unit would hang too low, so maybe mounted on side walls? BUT, there...

Really appreciate all the information. I went to Menards today and found that they have units that apparently have to be direct wired. Not an issue, but I thought a 120V unit could be plugged into a GFI outlet. Interstingly, the 120V is a "special order" while the 240V are in stock. The smallest...

I just did this on a 40x55 pole building. I installed steel ceiling and had fiberglass blown in to make it R40. Then I had side walls sprayed with closed cell foam, 2" thick. That seals all holes. The total cost was about $5300. I'm covering the foam with steel too.

"Does it need to be electric?" No, but it would be so much more simple if it were. This is not a daily use application, and unless I get kicked out of the house, I am not intending to live in the shop space (which is about 200 feet from my house) so I won't be needing it for a shower and a hot...

I am nearing completion of an auto shop for myself and wish to have hot water at a sink, so I am looking for something less than a "whole house" electrical unit. Can anyone make suggestions? I have seen a Tempura and also noted that Rinnani gets good reviews within thsi forum. Thanks, jim