Search results

I’m in.

I have the pro10 from Derek weaver. I lift my F250 and I’m 6’4”. I do have to duck my head when working, but it’s not a big issue. If you have any questions regarding build quality or install PM me.

Wera, whia, knipex

Some plumbers have the pipe freeze kits for just an occasion

I would see if someone could come out and do a wildcat dynamic test. It’s strictly a load bearing test for compaction. No soil samples are needed unless required.

Not to contradict redhead, because he knows metal buildings and the ins and outs. Almost every facility I have worked at bolts through the bottom on the purling. We never point load any one purling. We span multiple purlings with angle or strut and use square washers top and bottom to spread the...

Lancaster pole building built my 60x40x14. They did an awesome job. I’m not sure if they service your area. They didn’t nickel and dime you with everything.

I’m in the same boat. Ordered my weaver lift in June. Original expected delivery was first week of August. They are saying that the lift should be shipping any day now.

300’ assuming maximum panel utilization, puts you at 2/0 copper. That’s assuming you are drawing 125 amps at the panel…

Panasonic makes nice bathroom fans. Relatively quite and move a lot of air.

I’m originally from Clovis. If the soil hasn’t been disturbed I wouldn’t worry about it to much. The ground is probably about as hard as the concrete over it. Keep water from migrating around the slab and you will most likely be fine.

Send them back for a load bearing wall. If they are stamped correctly they can be used for load bearing, but they tend to be slightly fragile.

AB Martin has just about anything you will need.

That looks correct and will last a lot longer with minimal maintenance.

You use a grinder to cut the stucco. You will need to over size the hole to properly flash under the lath paper. I would also suggest using bitchathane sealant membrane in the corners lapped (slit past the ledger on either side. Membrane under the lath and over the ledger board). This will seal...

The correct leak free option is to cut back the stucco and flash from behind the lath paper. You will have a stucco repair, but you won’t have any leak issues or future maintenance. If you had an eave above the patio roof then lagging through the wall would be a valid option. Without the eave...

We use lubri plate FGL-2 on our higher temperature food machinery. $13 on Amazon for a tube. It’s food contact safe and non toxic.

My previous statement stands. Some 12” toilets are 11” or 11 1/2” or 11 3/4” center to rear of tank lid. So you either have to look at the toilet manufacturer cut sheets before buying or risk it not fitting.

The dimensions are heavily dependent on manufacturer. Your best bet is to look at the cut sheets for the toilet your planning on installing.

That almost looks like a RapidAir fitting.