Search results

Wondering if anyone has one of these or has used one and can comment on it.

Thanks, Forrest. Anyone else have any experience with bleeding their cart?

Did anyone bleed there cart per the instructions before use? I followed the instructions on my new cart (model 60438) and it caused me to overfill the hydraulic ram to the point where it wouldn’t go back down without any weight on it. I pushed the table down while holding the lever and the...

I have the Sunex 10 ton medium height pin type jack stands. The height works well for my 2019 duramax. https://www.amazon.com/dp/B0093NBQNA/?tag=atomicindus08-20

Doesn't look like it. In the second pic, it looks like a piece of flat bar that extends down where the wheel should be.

yeah, the head that's bolted on looks homemade and for a very specific use. I'd need to build something else to make it work.

I noticed that as well. The wheels on the OTCs are typically recessed into the square tube. The one I posted also appears to have a brace of some sort that used to run between the two legs. If you look at the second pic, there are two empty bolt holes on each leg.

Thanks for doing that. I was searching their site as well.

Fwiw, the guy selling it says it was bought, not built.

Looking for a heavy duty engine stand for a 24v cummins and came across this used one. Wondering if anyone recognizes it so I can verify the weight rating.

How would you go about making them?

Hi all, I've got a Roper Whitney box and pan brake (U-416) that is missing about half the fingers. I called Roper Whitney and its cheaper to buy an entirely new brake than it is to purchase replacement fingers. Does anyone know where I can get a replacement set of fingers for a reasonable...

Thanks for posting. Was contemplating a speedglass but couldn't pull the trigger due to price. This was a good alternative at a much lower price. Not warehouse but these are a big step up from harbor freight. Jackson Safety 46131 Insight Variable Auto Darkening Welding Helmet, HaloX, ADF...

https://sfbay.craigslist.org/eby/tls/6094425290.html 24" disc sander for $600. Brand is Unger. Table top is 1" thick

Thanks for the advice. Does anyone know where I can find how much LVLs weigh per foot?

About half of the footprint will be taken up by my tops for my 72 blazer and my 69 corvette, both of which are relatively light in terms of pounds per square foot, so i think 40psf should be fine.

Thanks everyone, especially bczygan. I had been researching this and saw that you are the resident expert and was hoping you would weigh in. Appreciate you taking the time to map out the entire design. Regarding the joist span, as others have said, the mezzanine will be 12’ deep. Which...

I'm looking to build a mezzanine in my garage that is 15' wide. The mezzanine would span 12' deep, but the LVL span tables online start at 20' spans. Does anyone know of any tables that would tell me what size LVL I should use? I'll be storing car parts and other heavy items (cherry picker...

Thanks, guys. I did a little research and it looks like these are the same type as those that were sold by a GJ member in this thread: http://www.garagejournal.com/forum/showthread.php?t=143568 The deep drawers are what caught my eye, but they don't open all the way. The come out 10" shy of...

This toolbox apparently belonged to a machinist, and am wondering if anyone recognizes it. It's 42" deep!