Search results

I made 2x10 ramps. 45 degree cuts and staggered back, 3 levels, first level was extended out a bit so tire would hold the ramp down befor accending the next 2 levels. Stapled sandpaper to the bottoms.

If you're at all handy its a couple guys an easy afternoon install.

I have the same issue, I use one of these: https://www.septicheater.com/

I found the outlet flap at the fan housing stuck closed on mine once.

Everything you can, put on wheels.

Maybe you could extend the opener antenna wire to outside the garage?

I've loosened the nuts to flush with the top of the bolts, and repounded back down then retourqed. Seems to work most of the time.

I made small pieces of cedar trim to match my windows.

Minneapolis, I just put it on in the fall so the jury is still out.

I used some of this. https://www.asphaltsealcoatingdirect.com/products/quik-joint-asphalt-crack-repair-tape-2-inch

If you're looking to boost you local signal look here. https://www.wilsonelectronics.com/

Google the CommScope part number and look for the rest of the system components. Also maybe how the cellular telephone system works.

Useless without associated electronics.

I've had that poster in my shop for awhile now. Its my go to 'What are you doing today?" answer. Just bought a 1984 boat, motor and trailer to teach the grandsons about fishing and boating. It needs a lot of PO un-puttering.

Mine came with a half bath downstairs and a 3/4 upstairs.

QSC is what I use Crown and Carvin are also good, I would stay away from the low end brands. I just put stick on feet on the bottom and stack them. They flow air horizontally. I use them in my main 2 channel bi amped system with the fans disconnected. They never even get hot.

The speakers are pretty efficient, so you don't need tons of power, but more is better than less. They are a 2 wire 8 ohm connection unless you biamp then and use a speaker controller DSP which is an advanced subject. The round connector in the middle is called a Speakon connector. It is a 2...

If you use Sikaflex, mask the edges, then overfill a bit, then shave off the overfill with a razor, its like a matt finish, but it seems to attract dirt and darken a bit.

Ordered the Electro Industries EMB-S-9 unit from houseneeds.com. They were able to will call it at the factory for me. They are made here in Minnesota in a town called Monticello about 40 miles NW of Minneapolis. I picked it up on Monday and installed it on Tuesday. The unit is very solid...

After getting two ridiculous quotes from local contractors. I ordered a Electro industries 9KW unit on the net and they are will calling it at the factory which is near me, I don't think the hydro shark units have the utility interrupt I need for off peak power pricing of .06/KWH. Its really...