Search results

  1. P

    Accurate; reasonably priced optical tach

    Some of the various tachometer apps for iOS/Android work quite well up to a couple thousand RPM. If it is a dark enough area, the strobe lights ones may be a little more accurate than the frame rate ones.
  2. P

    Humidity control: what to do first?

    If the heat is the wall heater in the photo, you may find heating with the minisplit to be better, also the cost differential for a unit that heats well is small and gives you options for heat. Either way, definitely consider 2 units if you end up needing more BTU - also addresses the 2 room...
  3. P

    Humidity control: what to do first?

    Do a real load calculation, and decide if you want the mini just for cooling/dehumidification or heating as well. If you want heat (which I am guessing you do) that will probably drive the sizing as I am sure your heat loads are much higher than your cooling loads. Also, remember this is a...
  4. P

    Humidity control: what to do first?

    A lot of folks are suggesting more ventilation, but that may actually make the issue worse. A others have said, the root cause of the condensation is the temperature of the floor dropping below the dew point of the air. Just looking at the weather for Indianapolis, the dew points are often...
  5. P

    Shed - Build, buy, or DIY "kit." Any input appreciated

    It sounds like this needs to be in a fairly prominent location relative to your beautiful new house. In which case I would for sure build a nicer looking shed - not the hokey mini-barn kits/prefab options. The premade ones look just OK on the day they are delivered and get progressively...
  6. P

    Question for the 12V Lithium battery guys regarding testing..

    The shunt is on the negative lead, but there is a small wire to the positive terminal to power the meter. You do need to get the battery all the way full to calibrate the meter to 100% SOC. Given the choice these days, I would buy a battery with a State of Charge meter built into the...
  7. P

    Plug in Solar - Virginia

    I don't think there is any rule or reason that you can't back feed solar into a breaker in a sub panel. I have 400A service, which feeds two 200A panels, so both of these panels are technically sub panels. My 10kW solar system back feeds a 50A breaker in one of these sub panels. I also...
  8. P

    Plug in Solar - Virginia

    It looks like your base load is on the order of 1.5 - 3kw depending on season. Plug in solar (or even a larger system) may be a good idea for you, as you don't need to worry about net metering, the 1200W from the system would just offset your usage, reducing your base load while the sun...
  9. P

    Plug in Solar - Virginia

    I am no expert on the rules and regs for VA, so you would need to read up on those. But from a purely physics perspective, plugging in to an outlet in the barn would be fine. That also looks like an ideal roof for solar. I think you are also finding out one of the other benefits of these...
  10. P

    Backup power solar generator

    I am not sure what sort of phone you have that needs a 180W charger (!!!). A 180 Ah/ 2kWh battery backup would run my 10W phone charger for a full week, or my critical loads (network gear and server) for about 20 hours. Again, this is depends on your needs - if you need to keep the...
  11. P

    Plug in Solar - Virginia

    It looks to me like your electricity rate is closer to $0.16/kWh (the distribution fees are typically per kWh), which makes the payback a bit shorter. For a 1200W system, you should be in the $1000 - $1500 range. Basically you need one of these , three 500W panels of your choice (~$0.50 / W)...
  12. P

    Plug in Solar - Virginia

    Plug in solar has now been approved in Utah, Maine, Virginia, Colorado, Maryland, New Hampshire, and Connecticut with more to follow. Ant-islanding is a safety requirement, but as you mention a hybrid inverter can still provide power to loads on the output side from solar and battery.
  13. P

    Backup power solar generator

    I am not sure about the specific ones the OP posted, but in general I don't think these are a scam. You just need to know what the appropriate application is. I stumbled on one while looking for a UPS for some critical loads. For the same price as a 'traditional' UPS that would back up my...
  14. P

    Backup power solar generator

    I can't say whether a battery/solar solution is the right thing for you. But I can say is that there are far better and more established vendors if it is the right thing for you - for example: https://us.ecoflow.com/ https://www.ankersolix.com/ https://www.jackery.com/
  15. P

    Plug in Solar - Virginia

    Yes it is. Depending on if/what your state adopts for plug in solar, this could make a small system like your are describing make a lot more sense. You can use a hybrid inverter both to charge a battery and back-feed the grid at what every the specified maximum power. If the grid goes...
  16. P

    Plug in Solar - Virginia

    In Colorado it is up to 1920W if you have a dedicated 20A outlet. Does it make financial sense? Maybe. You can figure it out for yourself using PVWatts: https://pvwatts.nlr.gov/ For my location 1900W system would yield about 2700 kWh per year - or about $300 per year, if you could use all...
  17. P

    Electric lawn tractor

    Most consumer grade lawn tractors are going to need some work to make it to 2-3000 hours. I know my Husqvarna certainly did. I don't know about the EGO, but at least you don't have to do the 'regular' maintenance like oil changes.
  18. P

    Electric lawn tractor

    Our neighbor has the EGO one, and they love it - no gas, no oil, no belts and super quiet and surprisingly fast. They went all in on EGO after they got this as the other tools are pretty cheap if you don't need to buy batteries. I also love how quiet it is, as their teenager likes to mow at...
  19. P

    Mini Split Install - Tools & equipment needed - First Install

    I am not an HVAC tech, but I have installed or helped install a few minisplits. I have access to UHP nitrogen so I have done a positive pressure test, but I have also never found a leak this way that didn't also show up on the vacuum test. I think my sample size is about 4, so I am not...
  20. P

    Mini Split Install - Tools & equipment needed - First Install

    If you have time, you can probably skip the micron gauge and even the nitrogen test. You can spend some time vacuuming the lines to get them as evacuated and dry as possible, then leave them under vacuum for at least 24 hours (or preferably longer) to make sure you have no leaks. A micron...
Top Bottom