Search results

Search the forum Search Articles
  1. T

    Tool for Square Holes in Metal

    Die filer. Very specialized tool but awesome to have around the shop! Sent from my iPhone using Tapatalk
  2. T

    VISE REPAIR 101 all vise repairs, lubricants, sources for parts and the tricks to fix

    A couple of easy questions. Where do I access the spreadsheet for locating parts? More specifically, I have a Columbian 224 1/2 with a bad spindle nut and maybe some replacement jaws. Thanks for your patience with my newbie question! Sent from my iPhone using Tapatalk
  3. T

    GIVEAWAY - Felo, Wiha, and Stahlwille

    Just sign in to their site. And great timing. Just looking at options for a new hex key set! Thanks again! Sent from my iPhone using Tapatalk
  4. T

    Craftsman drill press resto-mod

    Fantastic! I’ve scrapped two treadmills for the same reasons! Just waiting for the right reboot! Was planning on a small cast iron band saw and maybe a similar era belt sander. Thanks for the great write up! Sent from my iPhone using Tapatalk
  5. T

    Roloc on a cordless?

    I just put a Milwaukee M12 in my Home Depot cart. Anyone see a crazy good deal other than fleebay? Sent from my iPhone using Tapatalk
  6. T

    Why have i never seen this pocket knife multi tool before??!!

    Guess I’m a nerd with my pocket protector! I carry a Leatherman Skeletool and a Milwaukee Fastback compact. I run a building supply resale shop and you never know what will come through the doors! From boxes to carpet, the knife takes a beating and the Fastback can dump a razor blade for a new...
  7. T

    Looking for a Source to Buy Broken Power Tools

    Look to see if you have a Habitat for Humanity ReStore near by. I run one and many tools don’t make the cut to be resold. I have some great volunteers that save many but not all stores can. Several contractors rotate their tools on a 6 month cycle and bring their old stuff, working or not, to...
  8. T

    Need help identifying this barn find!

    Buffer/belt sander. Has Hart riveted to the front of the stand. Two motors with a reversing switch to run power. Belt sander is cast with “Wall HV-436” 110 volt and she works! The buffer is twin belt driven to pillow bearings holding the shaft. I could Not bid, right? Thanks for any insight...
  9. T

    WTD: Help for My Article About What Tools You'd Like To Be Gifted in 2018

    I’ve really been enjoying my new Zack rabbit countersink bits. Specialized but awesome for any level woodworking. Sent from my iPhone using Tapatalk
  10. T

    Table Mat

    May be too dense, but rubber stall mats from a local tractor supply? Different thicknesses and not expensive. 4x8x1/2” around $35 here in the Midwest. Sent from my iPhone using Tapatalk
Top Bottom