Search results

Has anyone noticed the light omitted from the SAMs club lights has a yellow tinge to it.? Sent from my iPhone using Tapatalk

Slowly working on getting the rake trim up and eventually the ridge cap. I think I am doing things a bit backwards which makes it more difficult. Normally I think you would have the siding on before installing the roof and especially the rake trim. What I decided to do is cut a few strips...

Got all the metal roof panels on and in place. The long side the panels were 23'6". Had to get a buddy over to lend a hand getting them puppies up on the roof. We built a ramp out of 2x6 and slid them up there. I've got all the wall sheathing up except that left side where the garage doors...

Sent from my iPhone using Tapatalk

Got all the roof deck on and covered in REX synfelt. Ordered roof metal yesterday. 1500sq ft for $1400. Includes all screws and trim and fillers. It's supposed to be delivered on Monday. Going to work on sheathing the walls until then. I had 40 more osb sheets delivered yesterday...

All the old siding is off. The porch is starting to take shape. Sent from my iPhone using Tapatalk

I got the roof sheathed with osb and I chose to go with a synthetic underlayment. Lifting all 40+ sheets of osb onto the roof by myself was not fun but it's done. Roof is about 3 inches out of square on one end, I'm not sure how I will hide this when I put the roofing on... I have...

It's a bad pic of them, they are in the shadows Sent from my iPhone using Tapatalk

If you look real close you will see hangers. Sent from my iPhone using Tapatalk

I have done all the work by myself so far. With the exception of digging the holes- the auger I rented the throttle on the handle was broke and had to get wife to turn the throttle up while I ran the auger. I'm going to be ordering the metal for the roof soon. Still getting quotes from...

Few more pictures, have been very busy lately Sent from my iPhone using Tapatalk

Got posts for one side in today. Progress has been slow. Doing all the work alone is a pain in the rear. I've had to replace more rotten wood than I originally thought. The ledger/header on both sides has been replaced. I have also doubled up on the rafters. Sent from my iPhone...

It had a layer of 1/2" poly foam with the foil on each side. And on top of that was plastic corrugated panels. The foam could not be salvaged. Most was eaten by varmints and what was left is soaked in pee from varmints. The plastics panels was just a terrible idea from the start. What a...

Roof is off. Still need to replace a few rotten purlins, all rafters look to be ok. Going to set posts this weekend and hopefully get roof sheathing done next week. Sent from my iPhone using Tapatalk

Today I sprayed it down with a heavy bleach mix let it sit and then power washed the interior. I could not believe what an improvement it made. Far less stink now. Most of the bird poop and other **** is gone including spider webs and such. I also tore out a little more of the siding. I...

Got it. Thank you. Sent from my iPhone using Tapatalk

I just looked in the manual for my generac pressure washer and it says using bleach in the soap siphon will damage the pump and void warranty. Is there another product to use or a different way to do this? Sent from my iPhone using Tapatalk

Here is some water damage to the purlins. I'm guessing I will replace at least these two and possibly a few more. Sent from my iPhone using Tapatalk

Finally found the phone #, office hours are 830-1030 and only open Tuesday and Thursday. Must be nice. Sent from my iPhone using Tapatalk

I have researched online the best I can and have not found anywhere that says I am required to pull permits for building or adding to my barn. Is this possible? How do I check for sure? I live in Berlin township, in Erie county, in Ohio. Sent from my iPhone using Tapatalk