Search results

How big of a hole? I have some forstner bits from Milwaukee that are large diameter and self fed that is great. But the 2-9/16" bit is $50 and the 3" is $80 Sent from my Pixel 2 using Tapatalk

How did you keep the Padauk from staining the other woods when you sand and finish? Sent from my iPhone using Tapatalk

I’d kill for some 59° weather in December here in Iowa Sent from my iPhone using Tapatalk

I pulled the trigger today and ordered a CNC. I got an X-Carve by Inventables; 500mm x 500mm and was $760 for everything. Sent from my iPhone using Tapatalk

Two questions: 1) How can I safely cut these raised panels? I used the table saw set at a 30° angle and brought the fence in about 1/2” away. I used one of my Micro Jig resaw tools and pushed it through. This was not very safe and didn’t balance the best 2) Should i glue the barrel hinges in...

Check out about 3:04 Sent from my iPhone using Tapatalk

I saw David Piccuito do something similar to this as a replacement for his jointer. How do you like it? Sent from my iPhone using Tapatalk

My issues with the holes are the waste pieces “gluing” back to the piece and worried that it’ll chip. Sent from my iPhone using Tapatalk

Two wine displays I just finished. If anyone has some suggestions about cutting acrylic and drilling holes that would be appreciated Sent from my iPhone using Tapatalk

I’d hog out as much as possible with a combination of different forstner bits before I went to the router. Less stress in the router Sent from my iPhone using Tapatalk

Does anyone have a router cnc? I’ve been researching these extensively lately, and I was wondering if anyone here had some experience. Sent from my iPhone using Tapatalk

Just finished a picture frame for my wife. Made from cherry I had left over from another project. I definitely remember why I don’t like miters, I always have issues with them coming together properly. Sent from my iPhone using Tapatalk

Went and got some lumber today and wanted to see what other people are paying for lumber. I picked up 8/4 cherry for $6.99/bf 8/4 Walnut for $13.99/bf 8/4 hard Maple for $6.99/bf and 4/4 Padauk for $9.99/bf. Seems like I might be getting gypped. Sent from my iPhone using Tapatalk

Another good bandsaw box video similar to the one Mr_P shared. Sent from my iPhone using Tapatalk

Rrich is that table from the Wood Whisper? Sent from my iPhone using Tapatalk

Why do you say that? Not that I disagree, I just want to know your reasoning. Sent from my iPhone using Tapatalk

How many coats of poly did you put on before you sanded? What type of poly did you use? I've done exactly what you've done and I've realized that Minwax Satin Poly is the best for the first three coats – doesn't matter whether you want the final look to be glossy or Satin. I personally put 5...

Not necessarily woodworking tip but building tip: Know where water lines are when you drill into concrete. Especially in old homes. Had to make this repair tonight because the old copper water pipe was only an inch under the surface. Needless to say the hammer drill punched a good hole through...

I finally have enough done in my new house woodshop that I can start doing some Woodwork again. Dust Collection Closet Planer corner This was the main thing that had to be fixed 70" was the highest I could bring the ceiling up to thanks to the ducting. But before I redid this area it was...

Does anyone own the Laguna 14|Twelve? I am going back and forth on buying one. I've heard nothing but good things but that's only been from salesmen and reviews. I was wondering if anyone from here had one. Sent from my iPhone using Tapatalk