Search results

Thanks everyone! I already had this heater, which is why I was hoping it would be easy to convert. I now understand that it’s not worth the hassle.

Thanks guys. That’s why I came here first. Another option is to have a natural gas line ran from my house to the garage (60’ run).

I have a Mr. Heater wall mounted ventless heater. It has a tag that says “use natural gas only”. I was wanting to hook it up to a 100lb propane tank. Is this possible? I found this regulator and hose (see link) at Menards. Is this made to allow the natural gas heaters to run on propane? Any help...

Abom79 uses evaporust all of the time on his YouTube channel. Makes old tools look new again. He sprays the items with CRC corrosion inhibitor afterwards.

I got it loaded in the truck. My concern with the arms was just the fact that I am not used to seeing the asymmetric type lift I suppose. I’ll keep you guys posted. I’ll get it set up tomorrow without bolting it down yet.

9,000 lb capacity

Hi, everyone. I am thinking about purchasing an older two post lift. I’ll attach photos below. My concern is that I can not seem to find the mounting recommendations anywhere on the internet. My concern is the recommended concrete thickness. My concrete is 5” thick with wire mesh reinforcement...

I’m going to price the dura panel also I’ll see how it compares to OSB price wise. I do have a Menards by me. The 11% discount comes as a store gift card that you get about 8 weeks later. Don’t get me wrong it’s still a good deal but you have to spend the savings at Menards.

Thanks guys. Thinking I am going to go the route of scabing a scrap piece of osb over the joints. I may price that dura-panel but I’m guessing it’s not cheap.

Thread chaser and new nuts would work. Or just remove the studs and use bolts and nuts.

That all sounds great except for what’s that durapanel cost per square foot?

So I am fixing to put 7/16” OSB on my ceiling in my pole building. My trusses are 24” centers. The issue comes with the length of my building, it is 27’ long. I was looking at using the 4’x9’ OSB that way 3 sheets would cover the entire length. The only issue with that is the fact that the ends...

We installed my 30’ gutters with three people and two ladders. One guy stayed on the roof with a rope that was tied to the center of the gutter on the ground. Then one person on each end climbed ladders with the gutter while the guy on the roof kept tension on the rope to support the middle...

Deleted comment. Thought you were looking for a wireless camera system.

Deleted comment. Thought you were looking for a wireless camera system.

Fill it full of helium. It will lift itself. You then just guide it into place.

Abom79 just finished his steel bench on YouTube. He used a wire wheel on his. He then used this CRS rust converter stuff. Looked pretty good when finished.

Thanks Tre. $71 a piece is pretty steep. I have a buddy that owns a machine shop. I will probably have to make a set and just have him run an end mill down them to make the slot. I was hoping to be able to buy them at a reasonable price. $145 is kind of out of the question for this vise.

Can I buy jaws for this Columbian Vise I bought this Columbian 5041/2M vise at an auction. One jaw was missing and the other is in bad shape. The jaws are slotted on the back. Which requires a mill to make a new set. Am I able to buy them or am I going to have to have a set made? Thanks for any...

If it’s going to be a high lift then you should be good. Your spring/ opener should be well above your outlets. If it wasn’t going to be a high lift then I would move the outlets up a foot or two.