Search results

That would probably be a better alternative, but I have already purchased the heater, and to minimize electrical work and propane lines I just want to stick with the one. Just trying to decide on the best place before cutting a vent hole in my ceiling. Thanks!

Still trying to get used to this forum. Do you see them now?

And this is what I was currently thinking, just not sure if it would work out that way. Basically pointing at the dart board that goes to the other side of the shop. I'm afraid if I place it in the middle and point it one direction or the other it will create a cold side and a warm side. So...

Snapped these pics last night.

My shop is made up of two sections that share a common wall. The original building is 30 x 40 uninsulated. The addition is 20 x 70 (original owner built as a batting cage for son) and shares a common wall with the 30 x 40. There is one garage door on the short end. It is insulated everywhere...

I wipe my woodworking bench down with tung oil from time to time. No real reason or science behind it other than I had some left over from a project and thought WTH. Made it look real nice!

Hi, my name is Adam and I have a tool addiction. I have a desk job by day, and do finish carpentry on some nights and weekends to support my tool habits. Found this forum because I sent a ball bearing from a ratchet flying through the air last night. Already found the info I needed and...