Search results

I use Milton A-style on my tools as they are push to connect. Not sure about air flow on these, but have had no problems with 1/2 “ impact and lug nuts. I use a Stedlin on the compressor just for noise Control. Being older with some hearing damage makes it very pleasant to unhook a longer...

I don’t have enough money left to pay attention.

I use one of these quite a bit. Find one that fits your hand well. I have to have the striking cap on the handle as I use it to remove a lot of trim. Mine is a Goldblatt I bought from the flooring store.

If your in a bind, chuck it up in the drill and grind it down. Custom is great for one off. Really good options given 👆 above.

I have done a few pool motor bearings, but have not seen a collar like that. If it is a pressed on spacer may be able to pull it with the bearing. Could put the puller on and heat it to see if it moves. Can you find that part on a parts list, see if it is a threaded part or shaft. Just...

That receipt is dated 1/25/17. Things may have changed since then.

I wish that were the case with my LS exhaust manifold bolts.

The ones featured in the Marine How To website. Think a earlier post eluded to a issue with availability now.

This is my oiler mounted over my tool box. The plews mount keeps it from getting banged around Or misplaced.

I love my HST Pros for heat shrink. Had them for about 4 years now.

Gap is closed on the plug. May not be the only issue.