Search results

Did you check the inlet pressure when the unit was running? It should remain constant. If it doesn’t you may have a partial blockage. Mine was working fine one day and it got real cold and wouldn’t light. I took a heat gun to the regulator at the 100lb tank and melted the ice and snow off...

My house garage currently has a 6-20R (double receptacle in a 2 gang box)for the dust collector on a 10-2 branch through a 30 amp breaker

Yes you are correct my TS is a 2hp. The jointer and planer are 3hp and require minimum 20 amp circuit with a 6-20 plug Thank you for your advice!

Starting to wire my shop and in doing a little research I am wondering if my proposed wiring is correct. My table saw is currently wired for 230 and full load rating is 8 amps. Obviously can go over that under load while cutting etc. Copied from manual: Nominal Voltage .........208V, 220V...

Hello everyone! New member here. I've been reading a lot of posts since I committed to building my own wood shop. Background: I started pulling building permits here in south central lower Michigan about 3 months ago after tons of research. After filing site plans and building plans along with...