Search results

Voltage test showed everything was good and all the connections were tight. So either a bad wire or just a cheaply made fixture. I replaced it with a basic security light and installed two flood lights. Not as aesthetically pleasing as the other but it going to function better then what I...

What's crazy is I've had the fixture for over two years and used the coil type bulbs without any issues up until about a month or two ago.

I have a standard outside wall light on the garage. It's a motion sensing light. It's been going through bulbs about 1 every 10 days. It functions correctly, I.e. Comes on at night when it senses motion and it goes off at he time I specified (5 minutes). But it keeps burning through bulbs...

I Ike that idea. Thanks. Pardon my ignorance but what is the "hamb"???? DJ

I have an upright 1/3 horse sump pump that's is only 1 1/2 years old with minimal use. It basically pumps out my a/c condensation in the summer. Well the cheap :sad:china made plastic pedestal broke so I replaced it with a cast iron pump. The motor works great, runs quiet. I just don't know...

I found an inexpensive flashlight, $25 and you can get it at wally world. Its very bright and I'd say it can light up an area around 100 yards away. yeah, its plastic but for $25 its a great deal.:thumbup: http://www.walmart.com/ip/Coleman-Max-Bubba/13848697 DJ

I have Googled it, in fact I have spent a couple of hours browsing trying to find the answer. And I didn't fin it so I came here to ask the collective. I guess I keep looking. DJ

I just traded for a Kennedy roll around box and it needs some touch up paint. I know Kennedy Sells their paint but they think it is gold for $25 a can!!!! Does anyone know of a cheaper paint that matches the kennedy brown? I know I won't get the wrinkle finish but I would just like some paint...

Would you like a little cheese with that whine!! LOL DJ:bounce:

Thank you for the compliment!!! LOL DJ

Holy cow!! That's what I needed. Thanks for all the info. Looks like a nice little challenging project. DJ

I pulled the set screws out so I could slide the pulley over to align with the motor pulley. It didn't look like a 2 piece shaft. DJ

More pics

I couldn't find anyway to remove the belt without taking the shaft off, but I don't see how to do that without damaging the bearings. The link belt may be the way to go. DJ

YES access to the grinder pulley is an issue. I need to put the belt around the pulley at the top but there is no way to slide the belt over it. DJ

A couple more pics. DJ

My neighbor gave me this little Craftsman bench grinder. It works really well but it needs a new belt. The only problem is I cannot figure out how to install a new one. The only way I see is to pull the shaft out. Is this correct? Any other solutions? Thanks DJ

I have a brand new heating element for a whirlpool/Kenmore dryer part number 4391960. No wiring just the element. $25 shipped DJ

I have a brand new in the box Amsoil panel air filter for a 1995-1999 ford explorer XLT, SOHC V6. Part number EaA122. $20 + shipping Paypal works for me. Ask questions if you have them. DJ

If they can't fix it while installed they will replace it. They won't pay for a an entire shower rebuild but no one will do that. DJ