Search results

I hooked up some air to these two fitting and saw some movement in the hydraulic clamping system, but then the front cover started leaking so I will be draining the fluid and remaking the gasket and going from there, not sure how much psi it will need? Thanks for your help

Hello garage journal I was looking for some help with this Daito GA 260w horizontal saw. Currently the saw powers on, but I cannot raise the saw blade, I am not sure what I am missing. I have tried to reach out to the person who sold it to me, but have not heard back yet. I did see the saw...

Thanks everyone for your help, I have enough info to move forward with, this will be my last post on this topic.

yes I am going to get that addressed as well, it should be pretty solid when all is done, thanks

I was told that the wall that I was talking about removing was originally an exterior wall and had some wood siding on it(which I have removed before the OP), but then someone over 20 years ago had a slab poured and extended the garage another 20 Ft further back. So I wonder if that is why there...

I was told that the wall that I was talking about removing was originally an exterior wall and had some wood siding on it(which I have removed before the OP), but then someone over 20 years ago had a slab poured and extended the garage another 20 Ft further back. So I wonder if that is why there...

Thanks, good question, I will write that down and ask.

I probably would lean towards an engineer coming in to check it out, I just dont want an inspection to go south where a spotlight could be put on me. I want to make sure the work I will be doing going forward is solid. This is a great help

That is correct this is the wall end of the original building. That would be great if I could add a rafter tie on both sides. I would be fine with a beam as well, What size beam would I be roughly looking for?

hope this helps, let me know if you need any more info, thanks everyone

Here are some outside photos of the garage. There is a side view of the garage where the garage has been expanded long before I move in, and there is an overlap on the roof shingles just to the right of the single overhead door.

Yeah, that is the step I will be looking at next with having an engineer look at it.

There is a roof truss above the wall, no second story

Hello I am new to the forum and wanted to see if I could get some suggestions/idea about how to proceed in removing this supporting wall in a garage. The garage is 20'FT wide and 50' long, but halfway there is a supporting wall separating the two sections in half. The support wall is 20' long...