Search results

“Out of towner“ ... sorry for my poor editing

Yeah ... pass, his pit bulls don’t look to friendly. I was an out oft owner who got the out of toner price because I believe that if a man says he can do ... I have no reason not to believe him. Just the way ive been raised. yeap, I got this sucker punch right in the mouth (and it hurts!!)...

It has NEVER seen production!!! It has never been in alignment ... full disclosure: I’m only guessing alignment is the problem .... I’m not a production guy, I’m a salesman who got sucked into this rip tide and I’m trying to find a way to survive through it. it has damn near killed all my...

I had it built... was in a rush hoping the guy knew what he was doing ... I was wrong and have thrown lots of good money down the drain unless someone can give me some help to resurrect this thing ... if possible.

Correction: I’d like to run 18,000 .... right now, I’m using another table saw with a single blade and running it twice ... doubling my labor (ouch)!!

Agreed, but it’s too far out of alignment to where polishing would help!

Who is the smartest table saw guy on this forums? how many teeth should this beast have on each blade? can you recommend a place to get them? can anyone “create” a hopper to feed saw? im listening? i run about 18,000 board feet a month through this. Specie = Canadian SPF, moisture content...

For every input of 2 x 4 (1 1/2” x 3 1/2”) I get three pieces of (1 1/2 x 1 1/16”).

2 x 4 =(1 1/2” x 3 1/2”)

Yes. Are you close to Starke FL? If you go, bring your “Redneck dog” too😊.

Should I start over or can this “creation” be adjusted so it can work as originally hoped?

way Too much friction. out of alignment. fence is welded need helm. would use an power feed. Had a Delta hooked but it decided not to work ... frustrating!

5 HP new motor input= 2 x 4 18” output= 1 1/2” x 1 1/16” x 18”

Need help with home made “red neck” table saw ... near Starke FL, who can help tune up this double blade table saw and get it running correctly?