Search results

I have done a search on Spectrum for Rust to Riches . Cant be found . Where can this show be seen ?

Went and looked today . I was wrong . Tucked in the corner of the bench for years , not able to see its face , and used regularly . And meaning to relocate it for years . Although its 1/2 HP . And in storage , check this one out .

Thanks ! I need to get it out of storage . But as I remember it is in working order . Need to check into the HP though . I like that model and may use it to replace the one in the garage . You did a great job on the restoration !

I believe I have the same one stored away in working order . I will check ASAP . What would one be worth if I decide to sell it ?

Here , in south New Jersey is one that could use some help also

Where can I get info on the value of this South Bend And it’s value

Can I get a value on this Arbil. It’s in my family’s basement.

Add ststes it sold Jan 5 ,19 for ---- YOu ready ? $825 :)

Im already in the game . I Found a nice FPU a few pages back

Here is a Columbian I had out in the shed . You boys made me do it ! The blue one is not mine but worthy of a post

That’s on the. To do list. Will do ! 😎

After searching the net . I have found several FPU's that have only one screw in the back My theory of apossible change of the worm may be possible . I have also seen pictures showing wood spacers between the Jaw & plate . With that I decided to add one hole rather than two And all is good now...

To Rusty & Joe Believe me I looked for any tell tale signs of other holes . None were found ! What I did was , I drilled a 3rd hole in the center of the worm nut . Removed the wood from the jaws . Now it fully closes & operates as it should . Who knows what may have happened during its...

That one looks good also ! Thanks . I agree . And believe it should have 2 bolts in the rear . I guess thats why there are 2 holes in what you refer to as the vise nut . I guess illl have to be carefull in alignment and drill & tap 2 more holes & plug the center one . Is it at all possible...

Now that makes sence ! I looked through 80 pages on E Bay , found 3 . All had 2 screws on back . But they were #326 which I believe is 4 in wide Jaw . Mine again is #328 and a 5 in Jaw . Now I could drill & tap two new holes and things would be fine . But I dont want to rush into that just...

I appricat your suggestion . Although I guess due to age I can not find the one I have . I did clean up the Jaw and can now read " Test # 328 & Made in Poland " But i still have to figure out the location holes and there alignment :lol_hitti

I guess Ill join the group As I recentlly picked up this one at an estate sale . Any comments as to its history would greatly be appricated .. On another note , id like input on a few findings of this Vise . First I noteced the wood between the jaws Never saw that before on any vise ! After...

Well I picked up another WS couple weeks ago While in the process of restoration ,The floor monster hid a part on me . The ring that holds down the spring cup of the plunger . My fix for that was found in Home Depot . I used 3 1/2 in E clips to make up for the thickness . That worked just...

I found this one on my way back from Disney last week So now Ol faithfull has a twin for company I was told they did not know if it worked but it did raise half way. When home it lifted a car but not to full hight . So I added oil and then it didnt go up at all . Well it lived in a barn so...

In need of a Torque wrench 3/4 in drive. Whats available ?