Search results

Thanks for your interest. Please contact Scott Pollock, 1-817-473-1702, he is our International Regional Sales Manager and does a lot of work in the Canadian Market. He will be able to direct you to the nearest distributor. Thanks again Notch!

Thanks PattenP! As to the discussion about symmetrical vs. asymmetrical we would recommend you consider our Versymmetric Line. Versymmetric lifts allow symmetric and asymmetric lifting application safely within the same service bay. To read more about the Versymmetric story check out this link...

I think you are on the right path with the peace of mind that ALI certified lifts bring. As far as buying a used lift from a dealership going out of business check out this page. Not to get too "salesy" (we want to be here for informational purposes) but you may want to consider what the...

We have been in business for over 28 years and we’re pleased to say that our products are American-made. Our line of car lifts is designed, manufactured, and distributed in our 140,000 square foot facility in Louisville, KY.

swharris: How much do the buses weigh? If they don't weigh over 3000 lbs, then we would suggest a 9k lb. floor plate lift (without an overhead bar) or a 2-post with column height extensions. Good luck with the construction project.

CLFP9 is a nice lift for the money – fits in short ceiling spaces and would work fine for light duty cars/trucks. It’s meant to be used as a symmetrical lift (vehicle’s center of gravity positioned between the columns) so with some vehicles you may run into tight space between an open door a...

Most two-post lifts are typically around 11 feet wide. However, a four-column mobile lift system may work better for your needs since space is a limitation. Also, a short rise and mid rise lift is perfect for brake and tire servicing needs, if you are not looking to store another vehicle...

Thank you, GeorgiaHybrid, for sharing our PDF on the forum. Height measurements for all our lifts can be found on our website. 79mudbugg: We hope the PDF was helpful, however, please reply to this thread if you have any other questions.

For vertical clearance, we recommend checking the height of the area where the lift is to be installed. Ceiling height clearance should be calculated based on the full raised height of the lift and the height of the vehicle.

For vertical clearance, we recommend checking the height of the area where the lift is to be installed. Clearance should be calculated based on the full raised height of the lift. The ceiling height required is typically between 11’- 11 ” and 14’- 9” depending on which Two-Post Surface Mounted...

Our recommended bay size is 25 feet long by 12 feet wide. Though, this recommendation is for our particular brand.

We recommend a screw pad height between 3 7/8” to 7 1/8”. No anchors should be installed within 8 inches of any crack, edge, or expansion joint. If these conditions cannot be met, a pad may be poured to accommodate a lift.

A portable mid-rise lift is a great way to increase the productivity in a shop. It’s like having a service bay anywhere, indoors or out. The motor on these mid rise car lifts is conveniently mounted to a Heavy-Duty tow dolly, making it easy to move and operate on almost any solid surface. Some...