Search results

Why don't you reach directly to Armorpoxy? Did you grind or profile the floor prior to the epoxy?

Doesn't look too bad. Once you get your "stuff" in there, you probably won't even notice.

Do tell?! What did you fill them with?

Looks really good! How smooth was your floor prior to putting the RB down? Did you have to do any floor prep?

I can't seem to find a good Gladiator Gear Track hook to my hold my Echo blower. It's an Echo PB-200 (older) handheld blower. Any recommendations? Pic for click:

Thanks guys. It's all working correctly (gauge removed from check valve and replaced with unloader tubing). I do need to replace the clear tubing I have with high temp black tubing. Where can I get this? I think it's 1/4" OD, 3/16" ID. It's pretty small. Harbor Freight didn't have it, I...

Wow! You know this compressor! I bought this used about 3 years ago for $75 from an auto trim shop. Minus the on/off switch not working when I bought it, it's been great. I think I put about $75 in parts (fittings, pressure switch, new drain valve, etc). Do you have any idea how old it is...

Yes, it's working great, but I didn't know that hose would get hot. I'll replace it ASAP with copper. Funny, I threw the original hose away. I remember it being black and flexible. I might check the auto parts store for an industrial hose. It's small though.

Thanks for the help everyone. Got it running correctly last night.

I just pushed some rubber tubing in and it fits and locks in. So I connect tubing from this to the check valve?

Does this pic help? The blue piece pushes in and pops out on its own.

Yes, I feel like we're getting somewhere. So now I know I need to get the the check valve connected to the unloader valve. Can I put a new unloader valve in on the port that I plugged on the check valve? Or is there a way to connect the check to my pressure switch? I don't see how /where...

Thank for your insight Zrexx. The pressure switch I replaced it with has an unloader valve, but not a port to screw the air line to unless I misunderstand how to install it (very possible). I thought the unloader in this switch would get the pressure from thank via it's (the pressure switch...

OK, this is starting to make sense now, thank you all for your replies. The press switch I have does have a built in unloader valve. I also added a 150psi safety valve that you can probably see in the picture.

Thank you for the response. Yes, I'm sure I have my terminology mixed up. The check valve is what I pulled. You should be able to see it in this pic behind the pressure switch. A little history on this compressor: A couple years ago, the on/off switch (incorporated into the OEM pressure...

I have a smaller Speedaire 2 stage compressor I use for occasional car maintenance and air nailers. It always worked great until recently. After building up pressure, the belt is very hard to turn and the motor ends up kicking the breaker in the main. Here's my troubleshooting steps and...

Got 'er done! Since I had a side splash, I left both the cabinet face and counter straight. The side splash filled the gap. Now onto the crown molding on top, but my compressor is having issues. Read that post if you want to help...

Yes, that's the side splash. I ended up cutting it last night. I actually "notched" the side by accident. My wife was holding the free end of the counter while I pushed it through the table saw. It started to bind, she got squirrely and it created a "notch". The side splash will cover...

OK, thanks for the advice. I think this is what my wife suggested (she's always right). Cut out like this?

Not the garage, but the adjacent laundry room! I'm putting new cabinets in with a counter top and sink. The counter butts up against a floor to ceiling cabinet that has a protruding face frame on the side. The counter won't fit flush against it. I have a side splash to install against it...