Search results

Search the forum Search Articles
  1. A

    Craftsman pro (Mayhew) prybars on closeout

    I picked up a set of these a few months ago. I just checked and the stated measurements are end to end.
  2. A

    Tons of Snap-On Screwdrivers. Hard Handle, Sets, Torx, Prybars, Etc

    I'll take this: E. SGDX45PNK limited edition 4 piece pink screwdriver set new in box. The corner of the plastic cover got torn, but the drivers have never been out of the box. $85 shipped. PM inbound.
  3. A

    The VISES of Garage Journal

    I used a microfiber cloth and a bunch of elbow grease. The electrolysis and wire brush did most of the work. I'm sure a buffing wheel would have been a lot easier and produced a better result (adding that to my 'Stuff to Get' list). Good luck with the Monarch. Can't wait to see the 'after'...
  4. A

    The VISES of Garage Journal

    Thanks! I talked to a guy at Yost and he said they moved from Muskegon to Holland 25 years ago. I've also seen older Yost vises marked Meadville, PA.
  5. A

    The VISES of Garage Journal

    Doh! Great idea, thanks!
  6. A

    The VISES of Garage Journal

    I've had the word 'vise' on my 'Stuff to Get' list for a while (it's a long list...). After being inspired by all of the great vise restorations in this thread, I decided to give it a try. I picked up an old Yost 203 on eBay. It was in good shape mechanically but wasn't much to look at...
  7. A

    Huge Lot of Snap On & Matco Tools

    I'll take #11 - the SWR2. PM inbound.
  8. A

    HUGE LISTING of Snap On tools

    Will take the following: T72 ratchet $40 TMX2 extension $5 SGDX40BO screwdriver set $20 Sending you a PM.
Top Bottom