Search results

Klein 2 pack of multibit screwdriver $5.72 in schereville IN might be at other stores also https://www.lowes.com/pd/Klein-Tools-2-Piece-Rubber-Handle-Assorted-Multi-bit-Screwdriver-Set/5014457519

Pneumatic nail remover

You can get offset head nails that fit clipped guns that “should” meet code

All i know is new houses in my neighborhood went up 25% since last year and I’m ok with that.

You can buy test gauges to check tank pressure not worth the expense for one use. But i would just crack the valve open, a full acetylene cylinder will have about 200 psi. The others full will be 2000 psi youll be able to hear if theyre full. Only do this outside or as eric said hook up the...

Search amazon for intek 206 carb

Cheaper to buy a new carburetor off ebay or amazon should be #798562. wire is probably for a light like snowblowers sometimes have. No used in this engines application.

I’ve used harbor freight furniture dollies to move a car before (pontiac grand prix)you can just put a piece of plywood on top if you’re worried about the tires

Hammer is made by vaughan for sears you can buy it at menards under the vaughan name. Sears discontinued it because of too many warranty claims and exchaged them for vaughan in the early to mid 2000’s. Same thing with the tape measures changed the color and stopped the lifetime warranty...

40#ll means 40 pounds per foot live load meaning 40 lb load per square foot 10# dl means 10 lbs dead load or the structure weight itself L/240 is for the deflection of the beam from the weight on it, usually in the center of the span.

Thread detector available at menards in the same aisle you took that picture.

I have a dbi sala that was linked above. Its heavy compared to my other harness that a cheap one from miller without a belt. If you’re hanging off a wall all day spend the money for a comfortable harness but if its for roofing just buy one of the kits in a bucket that has everything included.

Halo expensive but its worth it. It locks onto your hardhat and has rechargeable batteries that you can switchout.

The paper is the vapor barrier no need to put plastic over it. If it was unfaced insulation the plastic would be needed for vapor barrier.

Id say just use 4x8 sheets for a room that small. If you’re doing a whole house minimize seams. Screw a 3ft long 2x4 on the wall about an inch below the ceiling to hold the end of the sheet and make a t head to hold the other end and you can install it alone.

Yellow liquid on a floor is most likely urine

Not what you’re asking for but i have a wifi controller($25 on amazon) with a free app on my iphone. The app TuyaSmart lets you check the status of the door or get alerts. You can control the door from anywhere but you can just not connect those two wires if you only want to know if the dooris...

Gearwrench ratcheting are the only ones i use now. I have a set of northern tool and gearwrench non ratcheting that just sit now both are good thou.

Dirty carb will cause that. Get a welding tip cleaner and cleanout the jets

Water is your friend keep it wet whileyou cut. Or you can rent a hepa shopvac for cutting concrete the vacuum for silica have self cleaning filters. They thump every couple minutes to clean the filter. I would just kee it wet with a mist of water while you cut it.