Hounddog
Well-known member
The recent addition to Hounddog's Workshop.
As found. I've been lacking in the metal cutting department for some time and jumped at the opportunity to pick this up. It's previous employer was the USAF so I'm going to take a leap that it's got many years of service remaining.
My plan is to do a full restoration as I did recently did with a metal brake a few weeks ago.
All loaded up and ready to roll to the shop.
Here's the solders that were left behind...my break is newly finished but I eyed the Stomp Shear pretty hard...but as my shop space is quickly shrinking...I decided to go the plasma route to cut sheet metal. The National break could have been a good "flip" but I really had to push away from the table.
As found. I've been lacking in the metal cutting department for some time and jumped at the opportunity to pick this up. It's previous employer was the USAF so I'm going to take a leap that it's got many years of service remaining.
My plan is to do a full restoration as I did recently did with a metal brake a few weeks ago.
All loaded up and ready to roll to the shop.
Here's the solders that were left behind...my break is newly finished but I eyed the Stomp Shear pretty hard...but as my shop space is quickly shrinking...I decided to go the plasma route to cut sheet metal. The National break could have been a good "flip" but I really had to push away from the table.
Last edited: