To avoid these ads, REGISTER NOW!

Outdoor light question

N

nate379

Banned
Joined
Feb 2, 2009
Messages
7,279
Location
Palmer, AK
Can baseplate of outdoor light function as box to hold wiring junction?

If I run wire through wall, through vinyl J block and put connection there, is that correct? I think this is how it's normally done but I want to check.

I can't put a box behind because that will mean I cut a stud in 1/2 (light is centered to roof)

Light:http://www.lowes.com/pd_296861-8307...294798265__s?Ntt=utilitiech&page=2&facetInfo=
 
To avoid these ads, REGISTER NOW!
6

6768rogues

Banned
Joined
Nov 28, 2007
Messages
4,524
Location
Western NY
I usually use a Master Mount light block because it is deep enough to accept an inch and a half deep box. In a shallower block, you could use a ceiling pan.
 
A

Aceman

Well-known member
Joined
Jan 28, 2007
Messages
2,513
Location
Eastern Oregon
You have to use a box. Always.

What is the depth from the face of the siding block to the sheathing? They make pan boxes that are a 1/2" thick. I bet Home Depot even sells them.
 
To avoid these ads, REGISTER NOW!
OP
N

nate379

Banned
Joined
Feb 2, 2009
Messages
7,279
Location
Palmer, AK
Yeah about 1/2" or so.

So cut out big hole in the J block so box is exposed?

I'm going to pull one of my house outdoor lights tomorrow to see how those were done.
 
You must log in or register to reply here.
To avoid these ads, REGISTER NOW!
Top Bottom