To avoid these ads, REGISTER NOW!

HF Hydraulic Gear Puller 66657

C

ChevyEFI

Well-known member
Joined
Sep 2, 2012
Messages
8,861
Location
Phoenix, AZ
I tried to search the pass/fail thread without luck.

And only one (positive) review when searching the whole forum.

Anyway; I crushed a washer and am now grinding the nose off the jackscrew of my OTC 1040. Yeah, I should have bought an indexing plate tool for it. It looks like a 3-jaw isn't going to be an option based on clearance. Well, without significant further disassembly.

So is the 66657 2-jaw convertible? Convertable? :bounce:

Any other reviews? How about the usual "you're doing it wrong" posts? :thumbup:
thanks.
 
To avoid these ads, REGISTER NOW!
OP
C

ChevyEFI

Well-known member
Joined
Sep 2, 2012
Messages
8,861
Location
Phoenix, AZ
I found a way to use a 3-jaw.

I mis-read the capacity as 12". It's 9"something.

So I'll have to make extending straps.
 
To avoid these ads, REGISTER NOW!
OP
C

ChevyEFI

Well-known member
Joined
Sep 2, 2012
Messages
8,861
Location
Phoenix, AZ
Well, I had to unbolt an item and finagle it out of the way in order to use a 3-jaw. Once in place, it (and some 1" wide 0.25" steel straps) worked great. :pimpflash

I really like this hydraulic puller idea. I always had OTC 2-jaws up to this point.

I do need to order a new screw for my 1040.

And figure out how to adapt hydraulics to the gear installation task I'll soon be undertaking.
 
You must log in or register to reply here.
To avoid these ads, REGISTER NOW!
Top Bottom