WTB / WTT -- Craftsman Sockets

I would like to purchase or trade for the following Craftsman sockets. If possible, I would prefer that the sockets be -G- series. I will consider other stampings, but only if they were made in the U.S.A. (updated 04/04/16)


3/8" Drive 12 Point Standard: 1/4", 15/16", 1"

3/8" Drive 6 Point Standard Deep: 13/16", 7/8"
3/8" Drive 6 Point Metric Deep: 17mm

1/2" Drive 6 Point Standard: 3/8", 1-1/8", 1-3/16", 1-1/4"
1/2" Drive 12 Point Standard: 3/8", 19/32", 25/32", 1-3/16", 1-1/2"
1/2" Drive 12 Point Metric: 25mm, 26mm, 29mm, 32mm, 36mm

* sockets in red are deal pending


----------------------------------------------


If you happen to also be missing some Craftsman sockets, I have multiple duplicates of the following Craftsman sockets available for trade. Most of these sockets are -G- series. There are a few -G1-, -G2-, and -GK- sockets. All of them were made in the U.S.A. (updated 03/20/16)


1/4" Drive 6 Point Standard: 5/32", 3/16", 7/32", 9/32", 5/16", 11/32", 1/2"
1/4" Drive 6 Point Metric: 4mm, 5mm, 6mm, 7mm, 9mm, 10mm, 12mm
1/4" Drive 12 Point Standard: 3/16", 7/32", 1/4", 9/32", 5/16", 11/32", 7/16", 1/2"

1/4" Drive 6 Point Standard Deep: 1/2"

3/8" Drive 6 Point Standard: 3/8", 9/16"
3/8" Drive 6 Point Metric: 9mm, 11mm, 12mm, 13mm, 14mm, 15mm, 16mm, 17mm, 18mm
3/8" Drive 12 Point Standard: 3/8", 7/16", 1/2", 9/16", 5/8", 11/16", 3/4", 13/16"
3/8" Drive 12 Point Metric: 9mm, 10mm, 11mm, 12mm, 13mm, 14mm, 15mm, 16mm, 17mm, 19mm

3/8" Drive 6 Point Standard Deep: 3/8", 1/2", 9/16", 5/8"
3/8" Drive 6 Point Metric Deep: 13mm, 14mm



Thank you for looking, and please let me know if we can help each other out!

Re: WTB / WTT -- Other Tools

I would also like to purchase or trade for the following items. (updated 03/20/16)


Mac M8CW ..... 8mm 12 Point Combination Wrench
Mac M10CW ..... 10mm 12 Point Combination Wrench


Matco A7M6 ..... 1/4" Drive 6 Point 7mm Socket
Matco A10M6 ..... 1/4" Drive 6 Point 10mm Socket


Hard Handle Snap-on Ratchets With Dual 80 Technology

.

This thread is overdue for a bump. Thank you to the guys who have helped me out so far. My list of missing sockets is getting smaller.