454ragtop
Well-known member
- Location
- Carver, MA
- Price
- $175
SOLD I have a very nice Craftsman 150 floor model drill press for sale. It has the somewhat tough to come by multi/slow speed third pulley assembly. Nice table, no arc of shame, 1 minute divot on the edge of the center hole. Appears to have seen little use, good chuck with key. Has the quick set depth stop with the fine adjustment and has a foot switch to turn it off and on. Very little to no rust, doesn't even really need paint, mostly just a good clean and polish. One minor defect, 2 of the 3 feed knobs are missing some of the plastic where the shaft enters the knob, third one is fine. Works fine as is, or could probably be repaired with the same materials used to repair plastic steering wheels. $175 picked up in Carver MA (SE MA).
Thank you, Jim Bishop
PM, email, or ph 774-696-zero599
Thank you, Jim Bishop
PM, email, or ph 774-696-zero599
Attachments
Last edited: