Blackhawk Jack

[mountford]

Hello Guys picked this floor jack up a month ago which was going to be thrown out. From what i have seen on the internet i think it is a Blackhawk S13, is that correct? It looks similar to ones i have seen on the internet but doesnt have the light on the pump. The hydraulic pump/ram has been dismantled and ram shafts are all rusty. Has any one got a manual / exploded diagram of this and know what seals i require? Thanks

 

[CJDave]

http://www.blackhawkparts.com/index.html 423 622-8282. I bought a rebuild kit last fall from them and am right now stumbling my way through the rebuild. They sent a exploded view and parts list, NOT step by step instructions, with it at my request. Tom seems to be very knowledgeable. CJDave.

 

[Hiball]

Before you go dropping $100+ bucks on a seal kit, I would reccomend addressing those rusty rams, the Main Ram seals on the outside (Rod) and also on the High side of the pump piston. Any imperfections will quickly eat those seals up and leak like a sieve. It will also be beneficial to manufacture a tool to tighten the compression nut, it can be done with long punches but the angle of impact will deform the slots and you risk damaging them, along with the Ram and have "Zero" feel for how tight the nut is.

Good Luck.