Kellogg American K321 Valve Tools

[crrider]

Hello all,
I really enjoy all the interesting information on this forum and finally decided to post.

I recently acquired a Kellogg American K321 air compressor. During a thorough cleaning, disassembly and inspection I see it needs at least the low pressure exhaust valve replaced. And I plan to service all the valves and de-carbon the passages in the head. Does anyone have the four Kellogg American Special tools needed to service the valves? I would be willing to rent or buy these if available through a forum member. I know these can be made from old sockets etc. but prefer to rent or buy if someone has them.

Thanks for any help you can provide.

 

[Coolabah]

Hello all,
I really enjoy all the interesting information on this forum and finally decided to post.

I recently acquired a Kellogg American K321 air compressor. During a thorough cleaning, disassembly and inspection I see it needs at least the low pressure exhaust valve replaced. And I plan to service all the valves and de-carbon the passages in the head. Does anyone have the four Kellogg American Special tools needed to service the valves? I would be willing to rent or buy these if available through a forum member. I know these can be made from old sockets etc. but prefer to rent or buy if someone has them.

Thanks for any help you can provide.

Welcome to GJ ! Great idea to finally join a forum especially when you have lurked a while , and finally join when you want someone to answer a question that you have, and even better we are all happy to lend our tools to first time posters !!! Again, welcome ! I can not personally help you on this issue as around my neck of the woods, Kellog is a breakfast cereal. Please make sure you list your location , as there are very many forum members that I am sure would like to help you !

 

[Hop2it]

crrider,
I can't help you with the valve tool but I have a head from my compressor that needed the crank high pressure rod and piston which i couldn't find anywhere,if you would like the head send a pm
doug

 

[HOTFR8]

May I suggest you do an introduction here and ask about that in Tools or General Discussion. I also suggest you update your profile location as that will help you further.
Welcome to the GJ.