To avoid these ads, REGISTER NOW!

Module PA50AB

maven74

Member
Joined
Oct 25, 2017
Messages
8
I have a Modine in a room adjacent to my garage that has done something new on me. I went out this morning to turn up the thermostat since it finally got down below freezing last night. I found the pilot light out and the fan running. I’ve cut the power to the unit and the fan continues to run. I can’t get the pilot to light either. I’m no HVAC guy but I’m usually pretty handy with some instruction. Any thoughts?
 
To avoid these ads, REGISTER NOW!
OP
M

maven74

Member
Joined
Oct 25, 2017
Messages
8
Does have a thermocouple according to the manual I found and printed. I also found another thread on here where someone had the same problem. Fan blows but pilot/burner won't light. Seems there is a reset button on the top of the unit that should clear the problem. I'm going to give that a shot today. This thing is OLD but works great...when it's blowing warm air.
 

SALIV8

Well-known member
Joined
Dec 11, 2008
Messages
2,114
Location
chicago and s/w michigan
Thermocouples are super cheap. I'd replace that if it won't light.

You can check the voltage that the thermocouple is giving off but would need someone to hold the pilot lit and then check the gas valve end for voltage.
 
OP
M

maven74

Member
Joined
Oct 25, 2017
Messages
8
Thermocouples are super cheap. I'd replace that if it won't light.

You can check the voltage that the thermocouple is giving off but would need someone to hold the pilot lit and then check the gas valve end for voltage.

I cleaned the end of the thermocouple per the manual, re-lit the pilot and it seems to be working okay now. I shut it down after about an hour and then brought it back up. No issue. Thanks for they conversation!
 
To avoid these ads, REGISTER NOW!

Bretny

Well-known member
Joined
Jul 31, 2017
Messages
3,918
Location
Dutchess county NY
I had a similar issue with mine. Go outside to the fan blowing and no heat. Even cleaning and replacing the pilot and thermocouple didnt help. My issue was the small ribbon burners that connected all the main tubes were clogged with rust. I took a small drill bit and cleaned them up. That was about a year ago.

What it was doing was lighting one main burner and gas would build up, then light and blow the one lit one and pilot out.

If you shut power off anf your fan is still on i bet your not shutting the power off
 
To avoid these ads, REGISTER NOW!
Top Bottom