Need some help with hoses for a blast cabinet

[roastednuts]

I have a central pneumatic blast cabinet, bought it used for like $200 before the world went crazy.

The hoses have all rotted or worn through and and ID and OD are not printed on them.

Does anyone know what type of hoses to get to fix this up?

Its this model https://www.ebay.com/itm/175266212640

Not the smaller red one.

 

[GeoBruin]

I have a central pneumatic blast cabinet, bought it used for like $200 before the world went crazy.

The hoses have all rotted or worn through and and ID and OD are not printed on them.

Does anyone know what type of hoses to get to fix this up?

Its this model https://www.ebay.com/itm/175266212640

Not the smaller red one.

Are you refering to the air hoses or the pickup tube? The air hose is just air hose. You can get short rubber whip hoses in just about any length online, or from the likes of Harbor Freight or even home depot. Pay attention to the size fittings you need. 3/8" hose will often have 1/4" fittings while 1/2" hose may have 1/2" or 3/8" fittings, but there are exceptions. Try to replace the hoses with the same diameter hose so they will fit in the existing grommets.

 

[scooby074]

My cabinet isnt a CP, but its just air hose and that braided clear water hose on mine. Actual blast hose isnt used AFAIK (I dont know if they even make blast hose that small TBH). Take a couple chunks of whatever hose is left and match it to whats available at Home Depot. IIRC most of the hose on mine is 3/8 with the sand hose being 1/2".

 

[The Cobbler]

braided vinyl will be fine for the sand hose and is cheep. air hose for the rest .
sixes will depend, should be fairly easy to match up