Reverse wrench?

[FIXXNU67]

I came across this double box end wrench(craftsman v 43921 1/2"x7/16") and the 1/2" side is stamped 7/16" and 7/16" is stamped 1/2". Obvious defect. Is this common or is it something that might be worth something?

 

[Oldtuleguy]

Mistamps on tools are not typically worth much, unlike coins!

 

[nadogail]

I came across this double box end wrench(craftsman v 43921 1/2"x7/16") and the 1/2" side is stamped 7/16" and 7/16" is stamped 1/2". Obvious defect. Is this common or is it something that might be worth something?

Welcome to the Forum.

 

[Nutria]

Mistamps on tools are not typically worth much, unlike coins!

I have a wrench that is stamped "HappyTool- China," but I think that it's actually a 1930s Snap-On. Willing to sell.

 

[Nutria]

PS: FIXXNU67, yes, welcome to the forum.

​

 

[nadogail]

Craftsman Tools were a mite cluby compared to Proto & Snap-on, but were "good enough" for most of us.

 

[2oolhound]

Those were marketed towards dyslexic mechanics during the early roll out of the "V" series. A full set would be worth something.


*Italicized text usually indicates BS in my posts