Hello Garage Journal users! Can anyone tell me the difference between a Reznor model UADP and UADS other than the UADS draws outside air? Could I just add a flange to the intake air on the UADP and pipe in outside air? For about a $400 price difference I could buy a lot of flanges!
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Reznor UDAP vs UDAS
- Thread starter Braindead
- Start date
The UDAS is a separated combustion heater, not only drawing in outside air for cimbustion but completely sealing off the heat exchanger and burners from the inside air in the shop. This is a increase in safety factor when using flammable liquids or sawdust. The standard Reznor has its entire heat exchanger and burners open to the ambient shop air.
LS6 Tommy
Well-known member
For just general wrench turning I'd get a UDAP. if you're doing woodwork or a lot of painting, a UDAS.
Tommy
Tommy