You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Rockwell drill press
- Thread starter sweetipi
- Start date
These radial drill presses don't have much value IMHO. I'll throw out $100 + or -
Prices vary by region.
Agree
redmondjp
Well-known member
These radial drill presses don't have much value IMHO.
Unless you are a woodworker.
seber
Well-known member
Mine sold for $40 with an albrecht chuck on Ebay.
Packard V8
Well-known member
Up here, depending on how creative one is with describing the presumed versatility, $50-100.
jack vines
jack vines
crguy
Well-known member
Wouldn't have one of those goofy things in my shop.
gnpenning
Well-known member
Where's the chuck??
I paid like $15 for mine. I don't use it much but when I do I love it.
I paid like $15 for mine. I don't use it much but when I do I love it.
7th Kahuna
Well-known member
Slow to sell at $50 to $100 around here. If I were selling one, I don't think I'd expect more than $50. Between the missing chuck and the poor wiring, I think you are looking at $25 or less.
Last edited:
bubinga
Well-known member
Where are you?
There was one here, think he wanted $100.00, or $150.00 I forget,
Guess it didn't get too many "bites"
he offered it to me for $50.00
I was going to take it, but I never did.
I do woodworking.
What is the problem with these?
Think I heard they are not rigid enough extended out very far.
I guess more so for metal.
Post your location.
How do the chucks go on these?
MT # 2?
There was one here, think he wanted $100.00, or $150.00 I forget,
Guess it didn't get too many "bites"
he offered it to me for $50.00
I was going to take it, but I never did.
I do woodworking.
What is the problem with these?
Think I heard they are not rigid enough extended out very far.
I guess more so for metal.
Post your location.
How do the chucks go on these?
MT # 2?
bubinga
Well-known member
Fix the wiring before you post it.
Do you have the chuck for it?
I'll probably give you $50.00 for it if you have the chuck, and you are near me.
Do you have the chuck for it?
I'll probably give you $50.00 for it if you have the chuck, and you are near me.
7th Kahuna
Well-known member
What is the problem with these?
I have no personal experience with these, but i would guess a big part of the problem is that you can't push them up against the wall. For most users the radial aspect is unnecessary so they just end up taking up space.
bubinga
Well-known member
Sounds about right.
Sent from my MotoG3 using Tapatalk
Sent from my MotoG3 using Tapatalk