caupwhiting
New member
- Joined
- Aug 5, 2016
- Messages
- 1
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Vintage Montgomery Ward Jointer
- Thread starter caupwhiting
- Start date
DuroChrome
Well-known member
I have a similar one...it isn't as old as yours. I paid $120 for mine and thought I got a good deal.
Rileysan
Well-known member
Is that a home-made table or factory made? What about the motor? What size and what is the make/model or the motor? I can't tell from the photos but those will have an effect on the overall value.
A 4" jointer/planer is a bit on the small side and most woodworkers would prefer a 6" model, making this one more of a collectible than a useful tool. Because of this, the demand for this size is almost non-existent and the value, therefore, is subjective.
For a little perspective, when I was in the market for a jointer/planer a few years ago, I passed on a dozen or more well made, vintage 4" jointers priced at $50 or less before finally purchasing a 6" Craftsman "crown top" jointer with original stand, motor, and manuals for only $75 (they typically sell for $100-$150 so I got a great deal).
Best of luck with yours, but don't be surprised if you are only offered $50-$75 (or even less if that is a home-made wooden stand).
Brian
A 4" jointer/planer is a bit on the small side and most woodworkers would prefer a 6" model, making this one more of a collectible than a useful tool. Because of this, the demand for this size is almost non-existent and the value, therefore, is subjective.
For a little perspective, when I was in the market for a jointer/planer a few years ago, I passed on a dozen or more well made, vintage 4" jointers priced at $50 or less before finally purchasing a 6" Craftsman "crown top" jointer with original stand, motor, and manuals for only $75 (they typically sell for $100-$150 so I got a great deal).
Best of luck with yours, but don't be surprised if you are only offered $50-$75 (or even less if that is a home-made wooden stand).
Brian
Rick M
Banned
It will need bearings. $50-100 on average depending on where you live. Compare against the more common Delta 4". Who was the actual manufacturer?
-- Rick M
-- Rick M