Grey Pneumatic vs. Sunex Semi-Deep Impact Sockets

[The Critic]

GP is 3/4”
Sunex is 19mm

Not sure if this is the best comparison, but GP appears to be shorter and has slightly thicker walls. But the difference in wall thickness is extremely minimal.

 

[Tallpilot]

I like that the GP are fully stepped in the smaller sizes. I don't think the Sunex are.

 

[darkzero]

Not sure what you are trying to determine with this thread but FWIW I have the Genius Tools semi deep impact in 19mm.

It measures 52.3mm tall (the 21mm is the same). No easy to read laser etching, just stamping. Has the oring groove for pin through anvils. Not that I care about that feature, I don't have any impacts with the through hole anvil anyway. Made in Taiwan. But mine is 1/2" drive, looks like yours are 3/8"?

 

[The Critic]

Not sure what you are trying to determine with this thread but FWIW I have the Genius Tools semi deep impact in 19mm.

It measures 52.3mm tall (the 21mm is the same). No easy to read laser etching, just stamping. Has the oring groove for pin through anvils. Not that I care about that feature, I don't have any impacts with the through hole anvil anyway. Made in Taiwan. But mine is 1/2" drive, looks like yours are 3/8"?

Yes - mine are 3/8".

My main goal was to highlight that GP and Sunex are not the same socket. I have read numerous posts on here that they are the same product, just sold in different boxes.

 

[bubinga]

Yes - mine are 3/8".

My main goal was to highlight that GP and Sunex are not the same socket. I have read numerous posts on here that they are the same product, just sold in different boxes.

Are the GP and the Sunex stamped as well as laser etched or just laser etched?

 

[Fedwrench]

I like that the Sunex set goes up to 22 mm.