Vessel P1 VS USB220 high speed/high torque?

[SuzukiGS750EZ]

Hey guys. Ordered a vessel usb220 high torque and realized they had a high speed as well. Looking to install doorknobs, outlets, wall plates, furniture, disassemble electronics and maybe some automotive interior stuff. Which model would fit this well? I have no experience with them. I ended up canceling the order until I can get some clarification lol

 

[darkzero]

I would like to know also. I've been wanting one (on my wish list but not high on it) but I haven't actually looked into the models. I could be wrong but I seem to remember seeing somewhere, maybe on here or on YT, that there was a third model aside from the higher speed & higher torque models. And I think that person choose to buy that 3rd "unknown" model but I lost track of what the outcome was.

Without knowing what the 3rd one is, if there really is one, I think I would go with the higher speed model.... for the size of it & for me needs.

 

[SuzukiGS750EZ]

I would like to know also. I've been wanting one (on my wish list but not high on it) but I haven't actually looked into the models. I could be wrong but I seem to remember seeing somewhere, maybe on here or on YT, that there was a third model aside from the higher speed & higher torque models. And I think that person choose to buy that 3rd "unknown" model but I lost track of what the outcome was.

Without knowing what the 3rd one is, if there really is one, I think I would go with the higher speed model.... for the size of it & for me needs.

The third one is a 3 speed p1

 

[darkzero]

The third one is a 3 speed p1

Oh, in that case, I think I would choose that one. Small powered screwdrivers like this I always use for running the screw in or out so I would rather have a faster speed than the torque. I prefer to tighten by hand anyway for small screws. Thanks.

 

[SuzukiGS750EZ]

I see the P1 on ebay shipping from Japan.
Do these drivers get made on the counterfeit market or are they legit?
Also, what's the "plus" in the USB220 Plus?

 

[Odd-job]

I did the GJ thing and got both before the 3 speed came out which I "need" too. I think I think I am in the minority in that I prefer the low speed for most things as the high speed is lower torque and sometimes too fast to the extent I loosen a screw and then it tosses it into Narnia.

 

[four.cycle]

if you're concerned about "counterfeit", try bowerstool.com for Vessel.

Vessel makes WAY too many part numbers.

you're not going to find a distributor who carries every single part number of Vessel - there's just too many of them - too much money ******* in inventory for most of them - so they'll carry just a few SKUs. I had to use three different ebay vendors to get all three sizes of ball-grips in P1 short, P2 short, and P2 long.

 

[GeoBruin]

Here's the link to where I ordered my usb-c 3 speed.

VESSEL Electric Ball Grip Driver Plus 3-Step Switching Mode With 1 Bit 220USB-P1 | eBay

VESSEL Electric Ball Grip Driver Plus 3-Step Switching Mode With 1 Bit Electric Dora Ball Plus 220USB-P1. Accessories: 1 bit: (+) 2 x 100mm USB charging cable (1m). Equipped with 3 rotation / torque modes in one body!

www.ebay.com

I don't know how their pricing compares but the shipping was free and it's legit.