Who made this air hammer bit?

[ThePostman]

Who makes or made this air hammer bit? It's use was for removal of inner exhaust pipe. It basically separated the inner, then you release it from the tool and use a 16mm to crank it clockwise, which causes it to collapse in on itself. It was made in the USA.... Thanks!

 

[ThePostman]

Bump for the evening. Someone made this and rebranded it for a lot...

 

[ThePostman]

Really, no responses

 

[Spareparts]

Never seen one like that and I have been around for a long time, Their has been many times where it
would have been real handy, courious to see who made it.

 

[Fedwrench]

If it has a .401 shank, my guess would be either Ajax or the old Ken Tool air hammer bits which was bought out many years ago by Mayhew.

 

[Old Man Roger]

Never seen one like that either. Looks like it would stretch the outer pipe though. I’ve always liked the one that’s shaped like a nibbler for cutting inside pipe. Mostly just used the torch though.

 

[rustyzman]

Might also have been made by OldForge. They made a lot of those various bits for others. Been a while since I have seen that one.

 

[speed bump]

I took a quick look at Arrow and Ajax catalog and couldn't find one like that.

 

[metaleltr]

I did some digging to no avail. Reverse image search didn't even return any used options. I recall seeing it in catalogs but at this point I don't know which ones.

 

[rustyzman]

Lisle Catalog T-57 : Lisle Corp. : Free Download, Borrow, and Streaming : Internet Archive

60 p., illus., 27.9 cm, trade catalog

archive.org

Lisle. I knew it was out there somewhere.

 

[KnurledNut]

Lisle Catalog T-57 : Lisle Corp. : Free Download, Borrow, and Streaming : Internet Archive

60 p., illus., 27.9 cm, trade catalog

archive.org

Lisle. I knew it was out there somewhere.

Nice find. Here's the relevant excerpt from that link for everybody:

 

[ThePostman]

Great job!