What can I do with TWO Dayton with 1/11 reduction
- Thread starter Patineto
- Start date
Beerhippie
Well-known member
Do you have a drill press? Do you drill a lot of metal?
Absofreakinglutlly and she happen to have a One EYE Monster (silly since the weight is so off axis the whole head rotates really fast and resetting to Zero needs three hands)
I have work on gear reductions on helicopters but I varelly remember anything
I only know the Dayton spins super low but the torque is "winch-like-Scary" but I don't trusts the motor to not fail when lifting a heavy load like on a crane
Sadly (unless you know a trick the axle speed is far to low to really be effective on a drill press, my Walker has two sets of pullies (incase in really small space) but I don't think is enough ight range
Ps: this motors are AC/DC so I can install one of my reostates to control the speed and even reverse
Dohhh..
Maybe I need to look on Dayton page
Attachments
Metal..
Don't laugh I have a steelmax mag drill and those Anular cutters are like cheating
Attachments
Beerhippie
Well-known member
That's not fair!
Seems you could change the sheave stacks on your DP to increase rather than decrease the spindle speed? Not sayin' it would be easy....
Firebrick43
Well-known member
Make a nice size tumbler.
RTM
Well-known member
Use them to open a big garage door from each side¿. Reverse both to close.
Looks like a setup to push a boat on a log ride, so maybe keeping pressure on a line of things like beer kegs on a flat conveyor.
From the drill press, use the VFD to speed them up.
Looks like a setup to push a boat on a log ride, so maybe keeping pressure on a line of things like beer kegs on a flat conveyor.
From the drill press, use the VFD to speed them up.