Hub Tamer Elite Tooling Dimensions? Who owns one?

[timoboy]

I recently acquired an old Hub Tamer Elite. Unfortunately it’s missing the little disk that sits on the hub to allow you to push against to remove the outer bearing race stuck to the hub. See pic. Does anyone that owns one of these kits happen to be able to grab the thickness and diameter of the disk for me? Going to diy one since OTC wants $70 shipped for it!!! Thanks in advance!

 

[jimindm]

I have one of those, but it is buried since I bought the newer version.

I would just look up a few wheel bearings on different makes and see what the inside diameter is. I would guess they are all pretty close.

As far as thickness I would guess maybe 1/4 inch. Any size of plate steel should work.

If you have a bushing driver, about any adaptor in it should work.

 

[Itinerant]

I have the No. 6490 kit, I’m sure the part is the same, part number 503896.

The diameter is 1.580” and it is 0.285” thick.

 

[timoboy]

I have the No. 6490 kit, I’m sure the part is the same, part number 503896.

The diameter is 1.580” and it is 0.285” thick.

Thank you so much!!!! I really appreciate you taking the time to get those measurements for me!

 

[Itinerant]

Thank you so much!!!! I really appreciate you taking the time to get those measurements for me!

You’re welcome, glad I could help.