Gearwrench diffirentiation

[SuzukiGS750EZ]

How do you guys figure out which side is forward and reverse on the non switchable ratchet wrenches? I haven't been using mine long enough to develop that third sense. Any tips besides grabbing it and spinning it?

 

[lightning02]

iv heard people engraving some sort of mark or some tape/paint on one side so they know.

 

[firebox40dash5]

My flexheads have light serration on one side. There's also which way the open end is pointing on the combos. I use mine every day, and I still can't remember which is what for more than a couple minutes.

 

[warweapon762]

On some of my KD era stuff I just used an automatic center punch to mark forward from reverse.

 

[Skin]

offset of the open end is facing the direction of rotation.

 

[kams1973]

Use the angle of the open end.

Skin beat me to it.

 

[ekd663]

You push/pull on the longer side, where the open end hangs down a little further.

 

[Brownsfan]

Mine have an arrow and slight knurling on the rotation side

 

[SuzukiGS750EZ]

offset of the open end is facing the direction of rotation.

Very good! Just what I was looking for. Thanks!

 

[Wamsutta]

With Blackhawk, you get an arrow next to the ratcheting end. You also get a longer length for more leverage.

http://www.protoindustrial.com/images/880x880/BW-1313M.png

 

[bwringer]

I have a nearly unconscious habit of testing it with my finger on the way to the fastener. Just one click and it's set in my mind somehow.

 

[Nanashi]

I have a nearly unconscious habit of testing it with my finger on the way to the fastener. Just one click and it's set in my mind somehow.

This is what i do. Plus my gearwrench flex heads have a seated edge on the one side letting me know what's what.

 

[johno]

I have a nearly unconscious habit of testing it with my finger on the way to the fastener. Just one click and it's set in my mind somehow.

That's what I do.

 

[rtole]

I always use it the wrong way everytime I pick one up. Then I flip it. Never do I guess right. Not to say I tey to figure it out either. I just grab and go.

 

[Givl Reggin]

Some brands have arrows on the box end to show you.

Craftsman's are like that too...

I figured all brands had a direction arrow.

 

[lightning02]

Craftsman's are like that too...

I figured all brands had a direction arrow.

not all cman have it. think the ones made in china dont.

 

[jdl25]

I have a nearly unconscious habit of testing it with my finger on the way to the fastener. Just one click and it's set in my mind somehow.

Add me to this camp.

 

[SuzukiGS750EZ]

They ought to color one side red or stamp them. I'll try the open end orientation. I'm going to start using them in the shop soon so I'm sure I'll get used to em real quick

 

[ajchien]

I put a dot of blue paint on the side that is OFF. It's in a place that is unlikely to rub off due to contact with anything.


Sent from my iPad using Tapatalk