Dimensions for Snap-on 5213X50PV replacement handle

[robmack]

I've not had any luck finding out the dimensions for a Snap-on replacement part. This is the pull handle used on the KRA model roll carts, part number 5213X50PV. I need to know the center-to-center hole spacing for the mounting bolt holes and the vertical spacing between bolts.

I hope to use it to replace the handle on my vintage Snap-on (the old style handle is NLA). I hope the dimensions will be 12-3/4" C-C and 1" spacing between bolts.

Thanks for any answers.

 

[chadster1]

I've not had any luck finding out the dimensions for a Snap-on replacement part. This is the pull handle used on the KRA model roll carts, part number 5213X50PV. I need to know the center-to-center hole spacing for the mounting bolt holes and the vertical spacing between bolts.

I hope to use it to replace the handle on my vintage Snap-on (the old style handle is NLA). I hope the dimensions will be 12-3/4" C-C and 1" spacing between bolts.

Thanks for any answers.

I don't have one handy at the moment to measure but I would bet money that it fits. I used that exact handle on my KR562A to replace the original.

 

[robmack]

Did you reuse the original holes?

I called Snap-on parts and, according to the rep, tech support said this part would not fit. Your picture above proves otherwise.

I would very much appreciate if you could measure the bolt hole dimensions on your box above and post here, so that I could confirm fitment before I complete an order for this part.

 

[chadster1]

I used the original holes.

 

[robmack]

Chadster,

Thanks for your reply.

I received my Snap-on 5213X50PV replacement handle today and can confirm that it fits the roll cart perfectly, using the same holes provided for the original handle. For others who might be looking for a handle, the current production handles for the KRA series is backwards compatible with (probably all) earlier KRA series boxes produced by Snap-on.

 

[chrisingrassia]

OP-
Do you know if that exact same handle part no. works for the Classic workcenter hutch as well?

 

[Wamsutta]

OP-
Do you know if that exact same handle part no. works for the Classic workcenter hutch as well?

Geez man, that was almost 10 years ago.

 

[ChevyEFI]

Do you know if that exact same handle part no. works for the Classic workcenter hutch as well?

Are the bolt pattern dimensions in post 1 a match to the Classic workcenter?

 

[chrisingrassia]

Geez man, that was almost 10 years ago.

Why does that matter?

Are the bolt pattern dimensions in post 1 a match to the Classic workcenter?

Well I don't know what the 1" spacing means. My hutch only has two threaded holes to mount a handle to. Looks like the roll cabs have six total holes to mount a handle. I can't figure out if my hutch holes are even supposed to be for a lift handle. What else would those holes be for?

 

[ChevyEFI]

Looks like the 5213X50PV has two holes per side.
Are the work center holes 12.75" apart?