Thermostat wiring help

[David Paul]

Good evening all,
I am trying to straighten out a rats nest of thermostat wiring by my oil boiler. There a 3 zones. The wiring coming to the zone valves is a mess, connected by a mish mash of wire nuts, twisted and taped connections, etc.
I would like to use some type of wiring block to straighten out the wiring and make future service easier. Any thoughts on what to use?
Thanks
David

 

[rockwithjason]

google barrier strip and look around for one you like

 

[Mustang51js]

I would just straighten out the wires but leave them as is,maybe shorten them up a little. I don't see a place to mount a block since it can't touch the pipe

 

[aandpdan]

http://www.amazon.com/Taco-ZVC403-4-Valve-Control-Module/dp/B008VEP4W6

 

[David Paul]

http://www.amazon.com/Taco-ZVC403-4-Valve-Control-Module/dp/B008VEP4W6

I was not thinking this high tech, but now I can't do without.
I thank you, my wallet not so much

 

[Mustang51js]

You still need wires going to zone valves so it won't clean it up that much

 

[David Paul]

You still need wires going to zone valves so it won't clean it up that much

Yea, I think it will:

 

[Mustang51js]

Yeah but what I meant is you can just clean up wires that are there now, you still need the same amount of wires going to zone valves even with that control box installed