Ernst low profile wrench rail

[scissorman]

Does anyone know up to what size wrenches will lay on these things in a 2.25" drawer and still be able to open/close the drawer? I currently have a set of Snap-on wrenches from 3/8" - 1 1/2" and the 1 3/16" will fit using the Mac tools rails and i'm assuming since these Ernst rails lay the wrench alot flatter that I "might" be able to fit the remaining wrenches but wanted to see if anyone knows for sure. The exact Ernst rails in question are the 6050 model.

 

[dodge610]

I have 2 sets of those and i go from 3/8 to 1 1/4 and the 1 1/4 is only sticking up 1 3/4 at its highest point. Hope that answers your question.

 

[scissorman]

I have 2 sets of those and i go from 3/8 to 1 1/4 and the 1 1/4 is only sticking up 1 3/4 at its highest point. Hope that answers your question.

Sounds like they should work then.

 

[dodge610]

I have one set for sae and one for metric. Got them in my HF 4 drawer cabinet. I have the 4 and 5 drawer the drawers on those the 4 drawer has shallower drawers than the 5 drawer and everything works out fine for me.

 

[imalexodell]

I have a 22mm at the top of mine. The 24 fits, but I didn't like how close it sat to the top.

 

[scissorman]

Looks like I need to figure something else out as I have 22 wrenches that I would like on the same holder/rail system and the Ernst only holds 15 wrenches in a row.